Selex Plywood C/D No Structural AUS

SELEX® PLYWOOD CD No Structural AUS

Selex®Radiata Pine Non-Structural Plywood has a variety of uses throughout the construction industry, particularly when structural characteristics are not required, whether that means not bearing weight or in cases where there is no requirement to meet the construction codes of Australia or New Zealand. This product offers one side that allows for a certain level of closed and repaired defects, and a reverse side that allows for appearance defects and open defects, conditions that allow it to be used in several applications.

Front
Back

Main applications

Fences

Non-structural packaging

Kennels, mailboxes, dollhouses, DIY projects

General applications

Download Technical Sheet

 Download Certificates

General applications

Dimensions
1200 x 2400
Thickness (mm) 6.5 9 12 15 18 21 25
Thickness (Inches) 1/4" 11/32 15/32 19/32 23/32 13/16 1"
No. of layers 3 3 5 5 6/7 7 9
Density 480  - 550 kg / m³
Sanding grain 150 grit on front and 120 grit on back
Adhesive Phenol-formaldehyde that complies with Super E0 emission standard
Moisture content 8% a 12%
Forestry certification FSC® y PEFC™ certified products

Storage instructions

Selex® Plywood must be stored horizontally on a flat surface, in a dry place, and covered, over three wooden slats.

Recommendations for construction installation:

Selex® Non-Structural Plywood must not be utilized in structural applications, as described in AU & NZ construction codes; CD non-structural plywood does not comply with AS/NZS 2269. Use SELEX® BD STRUCTURAL PLYWOOD where structurally certified plywood is required



Selex® Radiata Pine Plywood Panel, which meets the highest standards in responsible forestry management, is guaranteed to utilize raw material originating solely from FSC certified, well managed forests and other controlled sources.